The Yocan Evolve Plus is a uniquely (just like its counter part, the Evolve) vaporizer but now with a bigger chamber and battery.
Yocan evolve plus how to load Guideline
The steps below are for portable vaporizer pens designed for use with oil concentrates.
Load Vape Pen
Step 1) Prepare your concentrate for loading by gathering a small amount on the end of a d ab tool. With most pens you’ll want to load a BB-sized amount at a time, or approximately 0.1g. Depending on the consistency of your extract and the depth of your coil you might even be able to put a little on the tip of your finger to load it.
Step 2) Gently apply your concentrate directly on top of the coil, and be extra careful not to actually touch the coil with your d ab tool. Usually your concentrate or oil will be a little stubborn and won’t quickly come off of the tool, so it’s OK to finagle it a little bit to get it off like you see in my animation, but seriously be gentle with your coils because they’re very delicate.
Vape pens with shallower and smaller atomizers are usually easier to load since the coil is closer to the top. Deeper atomizers that have a higher capacity can sometimes be tricky to load small amounts into.
If your concentrate is not mushy or pliable (shatter-like) then your best bet is usually to break it into very small pieces and load the chamber 30-50% full with most pens. Whatever extract you decide to use needs to be very clean and it needs to fully melt to a liquid when heated.
Step 3) “Prime the wick” before you start vaping, which melts your *** down onto and around the coil which helps the pen produce better vapor and more consistent hits right from the beginning. You don’t always have to do this with every vape, but sometimes if you don’t do it you might feel like your oil is being vaped away too quickly, especially the first few draws after packing it.
Step 4) Vape it up!!
Yocan UNI Box Mod In-Depth Review
Yocan Vape Pen
Yocan Vape Support